honda — Propellor/Gear Case/Extension Case/Oil Case

19. EXTENSION CASE/LOWER RUBBER MOUNT [1] LOWER MOUNT HOUSING 6 x 12 a. DISASSEMBY Remove the following parts. – Engine cover (P. 4-2) – L./R. engine under cover (P. 4-9) – Gear case assembly (P. 14-3 and 42) 1) Tilt up the outboard motor and hold it in the position by hooking the hoist hook on each of the three engine hangers. 2) Remove the three 8 x 30 mm hex. bolts and the three 8 mm washers, then remove the lower mount housing from the extension case. 3) Remove the 6 x 12 mm flange bolt from the extension case and disconnect the ground cable. [2] GROUND CABLE [3] 8 mm WASHER (3) [4] 8 x 30 mm HEX. BOLT (3) [1] 12 x 225 mm HEX.

BOLT 4) Holding the 12 mm self-locking nut with a wrench, remove the 12 x 225 mm hex. bolt, 12 mm self-locking nut and the two 12 mm washers. 5) Remove the lower rubber mount and the lower mount collar from the extension case. [2] LOWER MOUNT COLLAR [3] LOWER RUBBER MOUNT [4] 12 mm WASHER (2) [5] 12 mm SELF- LOCKING NUT 6) Remove the eight 10 x 40 mm flange bolts and remove the extension case from the outboard motor. Remove the two dowel pins. NOTICE Remove the extension case with care not to drop it. [1] UNDER COVER SEAL B 7) Remove the under cover seal B and the extension case grommet from the extension case.

[2] EXTENSION CASE GROMMET 8) Remove the circlip, and then remove the 26 mm washer and the vertical shaft bushing from the extension case (XC, XCC, XD and XCD types only). [1] XC, XCC, XD and XCD types only [3] 6 x 10 mm DOWEL PIN (2) [2] EXTENSION CASE 10 x 40 (8) [4] EXTENSION CASE 14-89 [3] VERTICAL SHAFT BUSHING [4] 26 mm WASHER [5] CIRCLIP