[1] POWER TILT SWITCH 3P CONNECTOR [2] STARTER CABLE [3] HARNESS BAND CLIP [4] CLIP A Clamp the alternator fuse cable. Clamp the starter cable. [5] ALTERNATOR FUSE CABLE [2] STARTER CABLE [6] CABLE BRACKET A Clamp the alternator fuse cable and the starter cable as shown. [5] ALTERNATOR FUSE CABLE [6]-1 ALTERNATOR FUSE CABLE [8] WIRE HARNESS CLIP [7] NEGATIVE (–) STARTER CABLE Connect the negative (–) starter cable by pushing the starter cable negative (–) terminal against the projection on the crankcase. Clamp the alternator fuse cable and the starter cable and check that the cables do not interfere with the shift arm.
[6]-2 ENGINE SIDE [7]-1 STARTER CABLE NEGATIVE (-) TERMINAL [7]-2 PROJECTION [6]-3 STARTER CABLE 2-52 [10] POWER T SWITCH ILT [9] POSITIVE (+) STARTER CABLE