honda — Steering Rod/Remote Control Box

4. INSPECTION Bl/W Bl/R • IGNITION SWITCH Check for continuity between the terminals with the switch in each position. Bl/Y Bl W/Bl : Continuity Bl: Black R: Red W: White Y: Yellow • INDICATOR LIGHT [OIL PRESSURE LIGHT/ OVERHEAT LIGHT] [1] SWITCH 1 Use a known-good battery. NOTICE [2] SWITCH 2 Connect the black, red and yellow terminals to the switch 1, 2 and 3 respectively, and apply 12V battery voltage to the black/yellow [gray] terminal. When the switch 1 is ON: Green light is ON. When the switch 2 and 3 are ON: Green light is ON. When the switch 2 is ON: Red light is ON. Color in the brackets [ ] is for the side mount remote control type only.

[3] SWITCH 3 [Gr] [4] 12V BATTERY [5] COLOR IN BRACKETS [ ]: SIDE MOUNT REMOTE CONTROL TYPE ONLY • INDICTOR LIGHT [MIL/ALTERNATOR INDICATOR LIGHT] [1] ALTERNATOR INDICTOR LIGHT NOTICE Use a known-good battery. Connect the white/blue terminal to the switch 1, red/blue terminal to the switch 2, and apply 12V battery voltage as shown. When the switch 1 is ON: Alternator indictor light is ON. When the switch 2 is ON: MIL is ON. [3] SWITCH 2 R/Bu [2] SWITCH 1 W/Bu Y/Bu [4] 12V BATTERY [5] MIL • EMERGENCY STOP SWITCH Attach the tester leads to the terminals and check for continuity.

[1] SWITCH CLIP 16-9 Wire Position E (Bl) IG (Bl/R) BAT (W/Bl) LO (Bl/Y) ST (Bl/W) OFF (Stop) ON (Run) START (Start) Switch clip position Continuity Set No Not set Yes Switch is pushed with switch clip being set Yes