[1] TP (THROTTLE POSITION) SENSOR 3P CONNECTOR [2] TP (THROTTLE POSITION) SENSOR [3] HARNESS BAND CLIP [4] POWER TILT RELAY 3P CONNECTOR [5] WATER LEVEL SENSOR 3P CONNECTOR [6] HARNESS CLIP Clamp the main wire harness and the water level sensor wire at its taped part. [19] MAIN WIRE HARNESS [3] HARNESS BAND CLIP [7] WIRE HARNESS CLIP Clamp the power tilt relay 3P connector, 2P connector and the 1P connector wires.
[8] TRIM ANGLE SENSOR 2P CONNECTOR [9] WATER LEVEL SENSOR WIRE [14] POWER TILT MOTOR WIRE [12] TRIM ANGLE SENSOR WIRE [10] POWER TILT MOTOR 2P CONNECTOR [11] SPEED SENSOR TUBE A [13] UNDERCASE GROMMET C • Clamp the power tilt motor wire, trim angle sensor wire and the speed sensor tube A. • Install the undercase grommet C aligning the taped ends of the power tilt motor wire and the trim angle sensor wire with the end of the undercase grommet C • Check that the wires and tube are not interfering with the front lock of the under cover front bracket. [13]-1 FRONT LOCK [13]-2 Wires and tube are not interfering with the front lock.
[13]-7 UNDERCASE GROMMET C [13]-6 SPEED SENSOR TUBE A [13]-3 TAPE [13]-4 POWER TILT MOTOR WIRE [13]-5 TRIM ANGLE SENSOR WIRE 2-56 [18] HARNESS CLIP [17] CLIP A [16] NEUTRAL SWITCH 2P CONNECTOR [15] ALTERNATOR FUSE CABLE