honda — Service Information

2-63 [1] 14 mm CLIPS • Clamp the power tilt motor wire, trim angle sensor wire and the speed sensor [1]-1 SPEE tube A. TUBE • Install the 14 mm clip aligning the tape end of the power tilt motor wire with the 14 mm clip end. • Tighten the two 5 x 10 mm rivet screws while pushing the respective 14 mm clips against the corresponding projection of the mounting case.

[1]-2 TRIM ANGLE SENSOR WIRE [1]-1 SPEED SENSOR [1]-3 D SENSOR TUBE A POWER A TILT MOTOR [1]-4 PROJECTIONS WIRE [1]-7 SPIRAL TUBE [1]-3 [1]-5 TAPE POWER TILT [1]-2 [1]-6 MOTOR TRIM ANGLE [1]-5 14 mm CLIP (2) WIRE SENSOR WIRE TAPE [2] GROUND CABLE [10] SPIRAL TUBE Set the spiral tube on the power tilt motor wire, trim angle sensor wire and the speed sensor wire as shown. [9] TRIM ANGLE SENSOR [8] TRIM ANGLE SENSOR WIRE [3] POWER TILT MOTOR WIRE [7] WIRE HARNESS CLIP Clamp the power tilt motor wire, trim angle sensor wire and the speed sensor tube A. Avoid clamping on the spiral tube. [6] [4] CORRUGATED TUBE SPEED Wind the corrugated tube SENSOR around the power tilt motor TUBE B wire.

Be sure that the tube is set upright. [5] MOTOR CORD BUSHING Pass the power tilt motor wire, [4]-4 CORRUGATED TUBE trim angle sensor wire and the [5]-1 TRIM ANGLE speed sensor tube B through the SENSOR WIRE motor cord bushing. Align the tape end of the power tilt motor [5]-2 SPEED SENSOR wire with the end of the motor TUBE A cord bushing. [5]-3 POWER TILT MOTOR WIRE [4]-2 POWER TILT MOTOR WIRE [5]-4 TAPE Set the spiral t on the power motor wire, angle sensor and the sp sensor wire shown. ube tilt trim wire eed as [9] TRIM ANGL E SENSOR [8] T S [7] WIRE HARN Clamp the po trim angle se speed senso clamping on t wer tilt motor wire, nsor wire and the r tube A. Avoid he spiral tube.