5 - 1 5 - 1 Circuit Descriptions Hydraulic Pump - Fixed Flow Component Key: Single Pump - Operation A Spur Gear - Idler B Spur Gear - Driven C Channel D Recess P1 Main Section P2 Secondry Section The hydraulic pump is a gear type. The basic principle of the pump depends on the meshing of the two spur gears A and B , one of which is engine-driven whilst the other is an idler. Oil is picked up on the inlet side of the pump by the gears and carried round between the gear teeth and the pump body. As the gears come into mesh the oil is forced through the pump outlet port.
Lubrication is provided by the hydraulic oil which is directed around the unit, via special oil ways, by the motion of the meshing gears. Double Pump - Operation Both sections P1 and P2 operate as described below: The basic principle of the gear pump depends on the mesh- ing of two spur gears A , one of which is engine driven while the other is an idler. Oil is picked up by the gear teeth on the inlet side of the pump and carried around betwwen the teeth and the pump body. As the gears come into mesh, the space carrying the oil is filled by a gear tooth on the mating gear, forcing the oil out of the space and the through the pump outlet.
The wear plates B are loaded towards the gears by pres- surised oil which is fed to the backs of the wear plates via channels C . This ensures that the clearance between the wear plates and gears is prevented from becoming exces- sive as outlet pressure rises. The side of each wear plate that faces the gears has two recesses D . The recess on the inlet side of the pump assists the flow of oil into the gear spaces, thus raising the cavitation threshold of the pump. The recess on the outlet side vents oil trapped between meshing gear teeth to prevent compres- sion loads on the bearings. 9803/3280 Issue 1 Purchased from www.WorkshopManuals.co.uk Section E Hydraulics Section E