www.WorkshopManuals.co.uk Loader Valve - Variable Flow Loader Shovel Spool The loader shovel spool operates in the same manner as the auxiliary spool, refer to Auxiliary Spool . 30 The shovel valve section also houses auxiliary relief valves (items 30 and 30A ). Under normal operating conditions, with the shovel in the 'carry' position, the mechanical linkage keeps the shovel level as the arms are raised, to prevent spillage of the load. If, as illustrated, the shovel is fully tipped when the arms are being raised, the shovel is unable to tip further, producing back pressure in the head side of the shovel rams and cavitation in the rod side.
As the arms continue to rise, the back pressure increases until it reaches the setting of A.R.V. 30A . This A.R.V. then opens, allowing the excess back pressure to be dumped to exhaust and prevent the rams and linkage from being damaged. The rod side A.R.V. 30 senses a higher pressure in the exhaust gallery than in the service port and therefore opens to allow exhaust oil to overcome the cavitation. 30A The shovel service may also be fitted with a ‘return to dig’ detent solenoid 12 . A278920 A279300 9803/3280 Purchased from www.WorkshopManuals.co.uk Issue 1 Section E Hydraulics Section E 7 - 5 Circuit Descriptions 7 - 5 12 PR P RLS LS 30 30A T 12 30 30A