JCB — Fitting Spool Seal

www.WorkshopManuals.co.uk Dismantling and Assembly Fitting Spool Seal Use the procedure described below to correctly install the valve spool seals: 1 1 Lubricate the spool, bore and O-ring groove with JCB Hydraulic Fluid. Move the spool to the position shown and then install the O-ring A in its groove. A 2 C 2 Move the spool to the position shown and then install the O-ring B . It is important to note that the spool must not be moved beyond the position shown, otherwise the edge of the spool (face C ) may damage the first fitted O-ring (item A ). B 3 3 Position the spool in its central position as shown.

Re- assembe the centering assembly, dust boot etc as detailed previously in this section. A276280 9803/3280 Purchased from www.WorkshopManuals.co.uk Issue 1 Section E Hydraulics Section E 55 - 10 55 - 10 Loader Valve - Variable Flow