JCB — Bucket Crowd Ram

Hydraulic Rams www.WorkshopManuals.co.uk Section E Hydraulics Section E 80 - 2 80 - 2 Removal and Replacement - Bucket Crowd Ram Removal Replacement 1 Park the machine on firm level ground, engage the parking brake and set the transmission to neutral. Lower the backhoe and loader end to the ground and stop the engine. Replacement is a reversal of the removal sequence. ! WARNING Fine jets of hydraulic fluid at high pressure can penetrate the skin. Do not use your fingers to check for hydraulic fluid leaks. Do not put your face close to suspected leaks. Hold a piece of cardboard close to suspected leaks and then inspect the cardboard for signs of hydraulic fluid.

If hydraulic fluid penetrates your skin, get medical help immediately. INT-3-1-10/1 DANGER Hydraulic Pressure Hydraulic fluid at system pressure can injure you. Before disconnecting or connecting hydraulic hoses, stop the engine and operate the controls to release pressure trapped in the hoses. Make sure the engine cannot be started while the hoses are open. INT-3-1-11/1 2 Vent residual hydraulic pressure from the backhoe hoses by operating the backhoe controls back and forth several times. Note: If a hose burst protection valve is fitted on the ram, the system will not vent.

Extreme caution must be used when releasing hydraulic connections - release the connections one turn and allow the pressure to dissipate. 3 Label and then remove the bucket crowd ram hoses A . Plug and cap all open orifices to prevent loss of fluid and ingress of dirt. ! CAUTION This component is heavy. Do not attempt to remove it unless its weight is held by a sling. Make sure that the sling is attached to a suitable lifting appliance. HYD 2-3/1 4 Fasten lifting straps to the bucket crowd ram, make sure that the weight of the ram is supported by the sling. 5 Remove the pivot pin retaining nut B and bolt C , remove the pivot pin D . 6 Remove the bucket crowd ram.

9803/3280 Purchased from www.WorkshopManuals.co.uk Issue 1