9803/3280 Issue 1 Actuation of the hydraulic pistons 10 and 5 is controlled via two position solenoid valves E1 and E2 When neutral is selected, solenoids E1 and E2 are deactivated and the flow of pressurised oil to the clutches is blocked. Springs 8 and 9 move the pistons away from the clutch plates and oil from both pistons is vented to the sump. When for example clutch A1 is selected to be engaged, solenoid valve E1 is energised and solenoid valve E2 is de- energised. Pressurised oil is diverted via cross drillings inside the input shaft A3 to the clutch piston 5 . Pressure from clutch A2 is vented to the sump via the solenoid valve spool E2 .
Oil is prevented from leaking by seals 6 on the pistons and ring seals 7 on the input shaft A3 . In the diagram, clutch A1 is engaged. The counter plates 3 and friction plates 4 are pressed together by hydraulically actuated piston 5 . Drive is then transmitted from the input shaft to the gear G1 . Clutch A2 is disengaged and no drive is transmitted to gear/plate carrier G2 . The gear is also free to rotate on the input shaft assembly. The clutch housings and input shaft are a one piece assembly A3 . The assembly is permanently driven by the engine via the torque converter. Clutch counter plates 3 are also permanenty driven via meshing teeth inside the clutch housings.
Clutch friction plates 4 are meshed with the gear/plate carriers ( G1 and G2 ). The clutches are of the wet, multi-plate type. The clutch 1 transfers drive from the input shaft A3 to either gear G1 or gear G2 depending on which of the two clutches ( A1 or A2 ) is engaged, transferring drive to the mainshaft. When neither clutch is engaged, neutral is selected. The forward and reverse clutch units are very similar in design and operate in the same way. The following description refers to one unit and can be applied to either the forward or reverse clutch units.
Powershift Gearbox Clutch Operation - Forward, Reverse www.WorkshopManuals.co.uk Purchased from www.WorkshopManuals.co.uk The 2/4 wheel drive clutch is similar to the Synchro Shuttle 2/4 wheel drive clutch. See Synchro Shuttle Gearbox, 2/4 Wheel Drive Clutch Operation . Clutch Operation - 2/4 Wheel Drive Clutch The mainshaft, layshaft and 6 speed units all incorporate one clutch and not two, as in the forward and reverse units. The operation of the single clutches is the same as for one clutch in the forward or reverse units. Clutch Operation - Mainshaft, Layshaft, 6 Speed † The valve E is shown using symbols.
For an explanation of how the symbols work, see Section E , Introduction to Hydraulic Schematic Symbols . 30 - 1 30 - 1 Systems Description Section F Section F Transmission Section F Transmission Section F