www.WorkshopManuals.co.uk 9803/3280 Purchased from www.WorkshopManuals.co.uk Issue 1 Section F Transmission Section F 36 - 1 36 - 1 Fault Finding Synchro Shuttle Gearbox - 2/4 Wheel Drive Clutch 4WD CANNOT BE ENGAGED In normal operation the 2/4 wheel drive clutch is spring loaded off and therefore disengaged to give 2 wheel drive. The clutch must be pressurised to give 4 wheel drive. Before starting the more detailed fault finding procedures - eliminate the obvious: 1 Check that the transmission oil level is correct. 2 Check that the fuse for the 2/4WD circuit is intact. 3 Check that the 4-wheel drive external pipework is not damaged and that the drive train is intact.
4 Check that all the electrical connections are clean and secure. Also check that the solenoid spool is not sticking (in the 2WD position). 5 Check that the mainline pressure is correct (see 'Low Mainline Pressure'). 6 Check that the pump flow rate is correct. If the fault is not rectified after eliminating the obvious, check the following: Possible Cause Remedy 7 Low mainline pressure 7 Identify if the fault is related to the 2/4WD disconnect: 7.1 Disconnect the external pipework to the 2/4WD clutch. Cap and plug open orifices. 7.2 Check the mainline pressure - if the pressure is correct, the fault must be within the 2/4WD (see step 8).
If the reading is still low check the transmission in the normal manner. 8 Low mainline pressure (due to 2/4WD clutch): 8.1 2/4WD solenoid spool sticking. 8.2 2/4WD solenoid spool O-ring failed. 8.3 Clutch shaft sealing rings leaking. 8.4 Excessive clutch shaft end float. 8.5 Wrong type clutch piston fitted. 8.6 Clutch piston O-ring failed. 8 Rectify fault: 8.1 Strip, clean and re-assemble solenoid valve, renew valve if required. 8.2 Renew O-ring. 8.3 Renew clutch shaft sealing rings. 8.4 Rectify fault, renew parts as required, reset end float (should not exceed 0.03 mm; 0.001 in) 8.5 Fit correct type clutch piston (ie, without bleed hole). 8.6 Replace clutch piston O-ring.
9 Defective 2/4WD clutch: 9.1 Worn friction/counter plates 9.2 Mechanical failure of 4WD unit 9.3 Incorrect clutch pack end float. 9 Rectify fault: 9.1 Inspect friction/counter plates, renew as required. 9.2 Strip and inspect 4WD unit. Check that the electrical and hydraulic circuits are functioning correctly. 9.3 Measure clutch pack end float (should be 1.0 to 2.3 mm). Correct as required.