JCB — Pressure and Flow Test

www.WorkshopManuals.co.uk Powershift Gearbox Pressure and Flow Testing TEST POINTS Before completing any of the transmission pressure/flow tests, make sure that the oil level is correct and at normal operating temperature (not less than 50°C). A - Mainline pressure B - Converter inlet/converter relief valve pressure C - Converter outlet pressure All gauges etc used in the following pressure/flow tests are shown in Service Tools . F - Pump flow (remove filter and fit adapters) J - Lubrication pressure ! WARNING Fine jets of hydraulic oil at high pressure can penetrate the skin. Do not use your fingers to check for hydraulic oil leaks. Do not put your face close to suspected leaks.

Hold a piece of cardboard close to suspected leaks and then inspect the cardboard for signs of hydraulic oil. If hydraulic oil penetrates your skin, get medical help immediately. HYD 1-1 Clutches: S - 2/4 wheel drive clutch pressure T - Forward low ratio clutch pressure U - Forward high ratio clutch pressure V - Reverse high ratio clutch pressure W - Reverse low ratio clutch pressure X - 6 speed clutch pressure (6 speed gearbox only) ! WARNING Take care when disconnecting hydraulic hoses and fittings as the oil will be HOT. Trans 1-2 Y - Mainshaft clutch pressure Z - Layshaft clutch pressure Other items: ! WARNING DO NOT go underneath the machine with the engine running.

Switch off the engine, apply the parking brake and chock both sides of all wheels before going underneath the machine. Trans 2-1 L - Torque converter relief valve M - Pressure maintenance valve Test Procedures ! WARNING If a 4 wheel drive machine is to be raised and the engine/transmission run, make sure all four wheels are off the ground and supported by axle stands. If only one pair of wheels is raised, the machine could still drive through the other axle. Trans 2-2/2 Pump Flow Mainline Pressure Converter In Pressure Converter Relief (Safety) Valve Pressure Converter Out Pressure/Oil Cooler Flow Rate Lubrication Pressure Clutches:- !

WARNING Under no circumstances must the engine be run with the transmission in gear and only one driving wheel jacked clear of the ground, since the wheel on the ground will move the machine. INT-3-1-16 Isolating a Suspect Clutch Individual Clutch Leakage Test 9803/3280 Purchased from www.WorkshopManuals.co.uk Issue 1 Section F Transmission Section F 66 - 2 66 - 2 Service Procedures