www.WorkshopManuals.co.uk 9803/3280 Purchased from www.WorkshopManuals.co.uk Issue 2* Section 3 Routine Maintenance Section 3 18 - 2 18 - 2 Hydraulic System Changing the Filter Element ! WARNING Fine jets of hydraulic fluid at high pressure can penetrate the skin. Do not use your fingers to check for hydraulic fluid leaks. Do not put your face close to suspected leaks. Hold a piece of cardboard close to suspected leaks and then inspect the cardboard for signs of hydraulic fluid. If hydraulic fluid penetrates your skin, get medical help immediately. INT-3-1-10/1 1 Position the machine on level ground. Roll the loader shovel forward and rest it on the ground.
Retract the extending dipper if fitted. Close the backhoe bucket. Swing in the dipper. Lower the boom until the bucket rests on the ground. Lower the stabilisers to the ground. Stop the engine. Remove the starter key. 2 Remove the element assembly a Remove screws A. Remove the cover plate B and gasket C Note: If gasket C is a rubber type it can be reused provided it is undamaged. If the gasket is a cork type it must be discarded and a new gasket fitted on assembly. b Remove spring D. c Hold handle E and pull the element assembly from the hydraulic tank. 3 Remove the element from its canister. a Hold canister F. b Hold handle E and rotate the element G 90° anti- clockwise.
c Pull on handle E, the element G should separate from its canister F. Discard the old element. d Remove and discard seal H. e Clean the inside of canister F. New machines are fitted with a 5 micron filter element which must be replaced at the first 100 hour service with a 10 micron filter element. 4 Fit the new element. a Fit a new seal H. b Make sure that seal J is fitted in the new element. c Push the element G into its canister F and rotate the element 90° to lock it into position. Check that the element has locked into position by pulling on handle E. d Install the element assembly in the hydraulic tank. *e Fit spring D and gasket C, (see ‘Note’ at step 2).
f Fit cover plate B and tighten screws A to 21 Nm (15.5 lbf ft). g Check oil level and replenish as required through filler. Fit and tighten the filler cap as described on previous page. E J G A H B C D F 399340 *