JCB — Removal and Replacement

www.WorkshopManuals.co.uk Calliper Removal and Replacement ! WARNING This is a safety critical installation. Do not attempt to do this procedure unless you are skilled and competent to do so. Installation and mounting of the parking brake calliper requires tightening of the mounting bolts to a specific torque figure. Do not attempt to do this job unless you have the correct tools available. 0010 ! WARNING Before working on the parking brake, park on level ground and put chocks each side of all four wheels. Stop the engine and disconnect the battery so that the engine cannot be started. If you do not take these precautions the machine could run over you. BRAK 8-8 !

WARNING Brake pads generate dust which if inhaled, may endanger health. Wash off the calliper before commencing work. Clean hands thoroughly after work. 13-3-1-3 Removal 1 Release the parking brake lever (lever horizontal). 2 Disconnect clevis A , note which of the three holes on the lever is used. 3 Undo locknuts B and disconnect the cable from the bracket D . 4 Support the calliper and remove the two mounting bolts and hardened washers C . Lift the calliper and bracket D clear of the brake disc. B B A Note: Do not remove axle mounting bracket F unless it needs to be renewed.

C D E C F A396181 9803/3280 Purchased from www.WorkshopManuals.co.uk Issue 2* Section G Brakes Section G 50 - 2 50 - 2 Parking Brake Replacement Replacement is the reverse of the removal sequence. 1 Locate the calliper on the brake disc and fit new mounting bolts C with hardened washers, torque tighten to 255 Nm (188 lbf ft). 2 Insert cable into bracket D, do not tighten locknuts B at this stage as the brake will need adjusting. 3 Refit the clevis A into the hole in the operating lever E as shown. 4 Make sure there is adequate freedom of movement of operating lever E to ensure a positive brake application, and that the lever returns to the rest position when the parking brake is released.

5 Adjust the parking brake, see Service Procedures, Parking Brake Adjustment. Never unscrew the clevis A to adjust the cable. Torque Settings Item Nm lbf ft C 255 188 *