JCB — Slide Hammer Kit Procedure

www.WorkshopManuals.co.uk Slide Hammer Kit Procedure The slide hammer kit is used to remove pivot pins that must be extracted, i.e. cannot be 'knocked through'. The purpose of this description is to explain how the kit and the various components are used to remove the pivot pins. The adaptors A that form part of the kit have a screwed thread at each end. One of the threads will always be M20 size, this is to accommodate the end stops, items B and C . The other end of the adaptor will have varying thread sizes to suit the different size of threads in the pivot pins. 1 Prepare the pivot pin, for instance, if fitted, remove the pivot pin retaining bolt.

5 Fit the 'slide hammer', item F , onto the slide bar as shown. 2 Determine the thread size of the pivot pin and then fit the appropriate adaptor A as shown. Use the spanner flats D to securely fit the adaptor. 6 Finally, fit another end stop, item C , at the end of the slide bar, as shown. The slide hammer kit is now ready to use. 3 Fit an end stop B onto the other end of the adaptor (M20 thread size), make sure that the adaptor threads are fully engaged. 7 To extract the pivot pin, slide the hammer along the bar until it contacts end stop C . Repeat this step until the pivot pin is released. 4 Fit the 'slide bar' E into the end stop. Again make sure that the threads are fully engaged.

8 To remove the slide hammer kit, reverse the steps described above. C B E F C A D S196900 9803/3280 Purchased from www.WorkshopManuals.co.uk Issue 1 Section B Body & Framework Section B 1 - 4 1 - 4 Service Tools