12. OPERATION 12.10 WORKING WORKING MODE SELECTION MODE The mode selector switches can be used to switch the mode to match the conditions and purpose of work, thereby enabling efficient operation. Use the following procedures to make the most effective use of each mode. e When the starting switch is turned ON, the working mode is set e@ to general operation mode (G.O.), so normal work can be carried out without needing to set the mode. If you want to change the initial position of the working mode that is set when the starting switch is turned ON, consult your Komatsu distributor. Set the most effective mode according to the type of work using working mode selector switch.
H/O O GO © F/O oO vO O BO oO CHO)A AD157770 Power Working mode Applicable work {power Power Heavy-duty down) Set pressure ° 9% up 40% down 9% up General operation Normal digging and loading 23% up 9% up 30% down 9% up mode operation Finishing mode operation (F.O) Lifting operation mode (L.O) Breaker mode operation {B.O) of digging (speed Speed 5 (G.O) amount up) Set pressure 5% up (H.O) Large Swift slow-down and loading in a short time mode operation max. ° Finishing, leveling and general hauling operation Positioning Breaker etc. operation NOTICE Never carry out breaker mode (H.O.) or active mode hydraulic equipment. operation in as this may heavy-duty operation result in breakage of 2-71