A WARNING: Failure to follow these safety precautions may lead to a serious accident. | ALWAYS APPLY LOCK WHEN LEAVING OPERATOR’S 6. GENERAL PRECAUTIONS SEAT @ When standing up from the operator's seat, always place the safety lock levers @ securely in the LOCK position. If you accidentally touch the levers when they are not locked, the work equipment may suddenly move and cause serious injury or damage. e@ When leaving the machine, lower the blade and ripper completely to the ground, set the safety lock levers @ to the LOCK position, then stop the engine. Use the key to lock all the equipment. Always remove the key and take it with you. Work equipment posture — See “12.17 PARKING MACHINE”.
Locking — See “12.21 LOCKING” AB30576B - MOUNTING AND DISMOUNTING Never jump on or off the machine. Never get on or off a moving machine. When getting on or off the machine, always face the machine and use the handrails and steps. Never hold any control levers or lock levers when getting on or off the machine. To ensure safety, always maintain three-point contact (both feet and one hand, or both hands and one foot) with the handrails and steps to ensure that you support yourself. If there is any oil, grease, or mud on the handrails or steps, wipe it off immediately. Always keep these parts clean. Repair any damage and tighten any loose bolts.
e@ When getting on or off the machine, or when moving along the top of the track, if you hold the handrail inside the door when moving on top of the track shoe, and the door lock is not locked securely, the door may move and cause you to fall. Always lock the door securely. Method of locking door — See AN112940 “11.6 DOOR LOCK”. AE313290 AL(87320 1-3