Komatsu PC210-6K — 15.1 BEFORE STORAGE

15. LONG-TERM STORAGE 15.1 BEFORE STORAGE NOTICE To protect the cylinder rod when the machine is not being used, set the work equipment in the posture shown in the diagram. (This prevents rusting of the cylinder rod) When putting the machine in storage for a long time, do as follows. Wash and clean each part, then store the machine indoors. If you must keep the machine outdoors, place it on a level place where it will not be subjects to floods and other natural disasters, and keep it covered. AM091090 Completely fill the fuel tank, lubricate and change the oil before storage. Apply a thin piston rods.

coat of grease to metal surface of the hydraulic Disconnect the negative terminals of the battery and cover it, or remove it from the machine and store it separately. If the ambient temperature is expected to drop below 0°C, always add antifreeze to the cooling water. Lock each control lock. lever and pedal with the lock lever and pedal Set the stop valve to the “lock” position on machines attachments. Install the blind plugs to the elbows. Set the selector valve to the “When chines ready for attachments. not use” position ready for on ma- 2-93