Komatsu PC210-6K — 21.2 TORQUE LIST

21. STANDARD TIGHTENING TORQUES 21.2 TORQUE LIST Unless otherwise specified, tighten the metric bolts and the torque shown in the table. nuts to FOR BOLTS AND NUTS a The tightening torque is determined by the width across the flats ® of the nut and bolt. If itis necessary to replace any nut or bolt, always use a Komatsu genuine part of the same size as the part that was replaced. Nm (newton meter):

1Nm = 0.1 kgm AD053380 = 0.74 Ibft Thread diameter | Width across of bolt (mm) (a) flat (mm) \ (b) ia ( SZ Nm oS J SS kgm 40054300 Ibft 10 13.2 + 1.4 1.35 + 0.15 | 9.73 + 1.03 13 31.4 + 2.9 3.2 + 0.3 23.2 17 65.7 + 6.8 6.7 + 0.7 48.5 + 5.0 12 19 112 + 9.8 11.5+1.0 | 82.6 + 7.2 14 22 177 + 19 18.0 + 2.0 131+ 16 24 279 + 29 28.5 +3 206 + 21 18 27 383 + 39 39 +3 282 10 + 2.1 14 + 29 20 30 549 + 58 56 +6 405 + 43 22 32 745 + 78 76+8 549 + 58 24 36 927 + 98 94.5 + 10 684 + 72 27 41 1320 + 140 135 + 15 973 + 100 30 46 1720 + 190 175 +20 | 1270 + 140 33 50 2210 225 | 1630 + 180 36 55 2750 + 290 280 + 30 | 2030 + 210 39 60 3280 335 + 35 | 2420 + 240 + 340 +25 + 250 NOTICE When tightening panels or other parts having tightening fixtures made of plastic, be careful not to use excessive tightening torque:

doing so will damage the plastic parts. 3-17