Komatsu PC210-6K — 24.2 WHEN REQUIRED

24. SERVICE PROCEDURE © The rubber of the rubber pin lock is torn, and the steel balls may come The rubber is broken and the steel balls come out easily out. AM091300 oO The steel balls are buried when they are pressed by hand. The steel balls can be buried when pressed with finger AMO091310 Clean the surface of adapter © and remove the soil from it with a knife. Use your hand or a hammer to push rubber pin lock @) into the hole of the adapter. When doing this, be careful that the rubber pin lock does not fly out from the adapter surface. CORRECT INCORRECT AMO031320 Clean the inside of point @, then install it to adapter @.

If there is mud stuck to it or if there are protrusions, the point will not enter the adapter properly, and there will not be proper contact at the mating portion. Fit point @ to adapter @, and confirm that when the pointer is pressed strongly, the rear face of the hole for the pin of the point is at the same level as the rear face of the hole for the pin of the adapter. Sticky material AM091330 3-37