Komatsu PC210-6K — 11.1 MACHINE MONITOR

11, EXPLANATION OF COMPONENTS Manual setting 1. When the time is displayed, depress clock switch (1) for 2.5 sec or more. 2. “C” flashes. 3. Pressing H switch @ increases hours and pressing M switch @ increases minutes. If switch @ or @ is pressed for 2.5 seconds or more, hours or minutes increase continuously. When the correct time is reached, press clock switch @). This completes clock setting. AD31347B Correct time setting 1. When the time is displayed, depress the clock switch for 2.5 sec or more. 2. “Cl” flashes.

3 When SET switch @) is pressed, the hour is rounded off for 0 to 14 minutes {(Examples] and rounded up for 45 10:14 becomes 10:00 10:45 becomes 11:00 When SET switch @ is pressed at clock, the correct time is obtained. When the correct time is reached, to 59 minutes. (rounded off) (rounded up) the time signal press clock AD324250 or standard switch @. This while the completes clock setting. If the machine starting switch informations has a fault, is ON. The error information monitor flashes and appears displays all error sequentially.

Monitor indications Error mode E02 PC-EPC valve system error E03 Swing E05 Governor CALL Non-operating brake system error system error error If any of these monitors flashes, see “16.6.4 ELECTRONIC CONTROL SYSTEM”. 6. SERVICE METER This meter shows the total operation hours of the machine. Set the periodic maintenance intervals using this display. The service meter advances while the engine is running - even if the machine is not traveling. The meter will advance of the engine speed. 868068.8Bh by 1 for each hour of operation regardless AM101380