Komatsu PC210-6K — 3.INTRODUCTION

3. INTRODUCTION 3.1 INTENDED This Komatsu USE HYDRAULIC e Digging e e @ Smoothing work Ditching work Loading work See the section 3.2 e EXCAVATOR is designed to be used mainly for the following work: work “12.15 WORK POSSIBLE USING HYDRAULIC EXCAVATOR” for further details. FEATURES This Komatsu HYDRAULIC electronics system. oO The monitor panel o © EXCAVATOR is equipped with various controls based on an advanced greatly facilitates daily maintenance and self-diagnosis. Working mode, travel speed, and active mode are selectable. Digging and lifting force can be increased by light-touch control.

(For details, see operation section.) Adjustable wrist control levers make operations smooth and easy. Air-conditioned operator's cab assures comfortable operation. Low noise level and smart urban-style design and coloring. Superb pumps. operating performance Low fuel consumption machine. 3.3 BREAKING Your Komatsu However, operating provided by powerful engine and controlled by an electronic control system high-performance hydraulic provides an environment-friendly IN THE MACHINE machine has been thoroughly adjusted and tested before shipment. the machine under severe conditions at the beginning can adversely affect the performance and shorten the machine life.

Be sure to break in the machine for the initial 100 hours (as indicated by the service meter.) During breaking in: e Idle the engine for 5 minutes after starting it up. e e Avoid Avoid operation with heavy loads or at high speeds. sudden starts, sudden acceleration, sudden steering and sudden stops except in cases of emergency. The precautions given in this manual for operating, maintenance, and safety procedures are only those that apply when this product is used for the specified purpose. If the machine is used for a purpose that is not listed in this manual, Komatsu cannot bear any responsibility for safety. All consideration of safety in such operations is the responsibility of the user.

Operations that are prohibited in this manual must never be carried out under any circumstances. 0-5