Komatsu PC210-6K — 11.3 CONTROL LEVERS, PEDALS

11, 3. LEFT WORK EQUIPMENT CONTROL (with auto-deceleration device) LEVER () A Warninc if any lever is operated when EXPLANATION OF COMPONENTS N > in the deceleration range, the © engine speed will suddenly increase, so be careful when operating the levers. This Arm @® lever is used to operate the arm operation and upper structure. AN113300 Swing operation Arm OUT © Swing Arm IN © Swing to left to right N (Neutral) When the lever in this position, the upper structure and the arm will be retained in the position in which they stop. 4.

RIGHT WORK EQUIPMENT CONTROL (with auto-deceleration device) LEVER A WARNING If any lever is operated when in the deceleration range, the engine speed will suddenly increase, so be careful when oper- ating the levers. This lever is used Boom operation da @ to operate the boom and Bucket operation RAISE LOWER @) @ DUMP CURL N (Neutral) When the lever in this position, the boom retained in the position in which they stop. For levers 2, 3 and AN113310 bucket. 4, the engine speed and the bucket will be changes as follows because of the auto-deceleration mechanism.

e@ When the travel lever and work equipment control levers are at neutral, even if the fuel control dial is above the mid-range position, the engine speed will drop to a mid-range speed. If any of the levers are operated, the engine speed will rise to the speed set by the fuel control dial. e lf all control levers are set to neutral, the engine speed will drop by approx. 100 rpm, and after approx. 4 seconds, the engine speed will drop to the deceleration speed (approx. 1400 rpm). 2-21