12. OPERATION 12.1.4 OPERATIONS ENGINE AND CHECKS BEFORE STARTING A WARNING If the control lever is touched by accident, the work equipment or the machine may move suddenly. When leaving the operator's compartment, always set the safety lock lever securely to the LOCK position. AE313600 1. Check that safety lock lever G) is at the LOCK 2. Check the position Set the control lever. lever to the neutral position. starting the engine, never touch the knob button. Insert the key in starting switch @, turn the position, then carry out the following checks. key (1) The buzzer will sound for approx. 1 sec, and the monitors and gauges will light up for approx. 3 sec.
Radiator water level monitor @ Engine oil level monitor @ Hydraulic oil level monitor © Charge level monitor © Fuel level monitor @ Engine water temperature monitor Engine oil pressure monitor © to the ON AN112930 following I 3. LYVLS When of each position. AM03907 10 Engine water temperature gauge Fuel gauge qi) Engine pre-heating monitor 4) Air cleaner clogging monitor 43 Swing lock monitor Engine oil replacement If the monitors or gauges monitor ¢ do not light up or the buzzer does not sound, there is probably a broken bulb or disconnection in the monitor wiring, so contact your Komatsu distributor for repairs. After approx. 3 sec, the following gauges other monitors will go out.
e Engine water temperature gauge e Fuel gauge qi) (2) will remain on Press lamp switch to turn on the head lamps. If the lamps do not light up, there is probably a broken and the bulb or disconnection in the wiring, so contact your Komatsu distributor for repairs. AM090290 2-51