• Fixed-speed isochronous governing with three switch-selectable speeds • Fuel enrichment and spark timing modifiers for temperature and fuel type • Transient fuel enrichment based on rate of change of TPS • Transient wall wetting compensation for gasoline • Input sensor selection and calibration • Auxiliary device control for fuel pump, fuel lock-off solenoid, tachometer, MIL, interlocks, vehicle speed limiting, etc. • CANBus data transfer for speed, torque, etc. Limp Home Mode The system is capable of "limp-home" mode in the event of particular faults or failures in the system. In limp-home mode the engine speed is approximately 1000 rpm at no load.
A variety of fault conditions can initiate limp-home mode. These fault conditions and resulting actions are determined during calibration and are OEM customer specific. Service Tool A scan tool/monitoring device is available to monitor system operation and assist in diagnosis of system faults This device monitors all sensor inputs, control outputs, and diagnostic functions in sufficient detail through a single access point to the SECM to allow a qualified service technician to maintain the system. This Mototune software (licensed by Mototron Communication) is secure and requires a crypt- token USB device to allow access to information.
LPG Fuel System Operation The principles outlined below describe the operation of MI-07 on an LPG fuel system. An LPG fuel system consists of the following components: • Fuel filter • Electric fuel lock-off solenoid valve • Fuel pressure regulator/vaporizer • Two orificed fuel trim valves • Gas/Air mixer with fixed orifice for trim system and fuel temperature sensor • Miscellaneous customer-supplied hoses and fittings Fuel is stored in the customer-supplied LPG tank in saturated liquid phase and enters the fuel system from the tank as a liquid and at tank pressure.
Fuel passes through a high-pressure fuel filter and lock- off solenoid, and is then vaporized and regulated down to the appropriate pressure to supply the mixer. The regulator controls the fuel pressure to the gas/air mixer. Tamper-Resistance Special tools, equipment, knowledge, and authorization are required to effect any changes to the MI-07 system, thereby preventing unauthorized personnel from making adjustments that will affect performance or emissions. Diagnostics MI-07 is capable of monitoring and diagnosing problems and faults within the system.
These include all sensor input hardware, control output hardware, and control functions such as closed-loop fuel control limits and adaptive learn limits. Upon detecting a fault condition, the system notifies the operator by illuminating the MIL and activating the appropriate fault action. The action required by each fault shall be programmable by the OEM customer at the time the engine is calibrated. Diagnostic information can be communicated through both the service tool interface and the MIL lamp. With the MIL lamp, it is possible to generate a string of flashing codes that correspond to the fault type.
These diagnostics are generated only when the engine is not running and the operator initiates a diagnostic request sequence such as repeated actuations of the pedal within a short period of time following reset. Other system features include: G643(E) Service Manual Chapter 5. Engine Management System (EMS) 151