Doosan G643 LP Engine — Doosan G643 LP Engine User Manual

A pressure/force imbalance begins to build across the air valve diaphragm between the air valve vacuum (AVV) chamber (above the diaphragm) and atmospheric pressure below the diaphragm. Approximately 6 inH2O (14.945 mbar) of negative pressure is required to overcome the air valve spring force and push the air valve assembly upward off the valve seat. Approximately 24 inH2O (59.781 mbar) pulls the valve assembly to the top of its travel in the full open position. The amount of negative pressure generated is a direct result of throttle position and the amount of air flowing through the mixer to the engine.

At low engine speeds, low AVV causes the air valve diaphragm assembly to move upward a small amount, creating a small venturi. At high engine speeds, high AVV causes the air valve diaphragm assembly to move much farther creating a large venturi. The variable venturi air/fuel mixer constantly matches venturi size to engine demand. A main mixture adjustment valve on the fuel inlet of the CA100 is not used in the MI-07 system, however an idle mixture adjustment is incorporated into the mixer (Figure 12). The idle mixture adjustment is an air bypass port, adjusting the screw all the way in, blocks off the port and enriches the idle mixture.

Backing out the idle adjustment screw opens the port and leans the idle mixture. The idle mixture screw is a screw with locking threads that is factory set with a tamper proof cap installed after adjustment. Accurate adjustment of the idle mixture can be accomplished by adjusting for a specific fuel trim valve (FTV) duty cycle with the Service Tool software or with a voltmeter. NOTE: Adjustments should only be performed by trained service technicians. Figure 12. Idle Mixture Adjustment Screw (with tamper proof cap removed) Figure 10. Bottom View of Air Valve Assembly Figure 11. CA100 Mixer Installed with Electronic Throttle G643(E) Service Manual Chapter 5. Engine Management System (EMS) 156