Doosan G643 LP Engine — Doosan G643 LP Engine User Manual

There are multiple limp-home modes available with electronic throttle control: 1. If the throttle itself is suspected of being inoperable, the SECM will remove the power to the throttle motor. When the power is removed, the throttle blade returns to its “default” position, approximately 7% open. 2. If the SECM can still control the throttle but some other part of the system is suspected of failure, the SECM will enter a “Reduced Power” mode. In this mode, the power output of the engine is limited by reducing the maximum throttle position allowed. 3 . In some cases, the SECM will shut the engine down. This is accomplished by stopping ignition, turning off the fuel, and disabling the throttle.

Ignition System Control Spark-ignited engines require accurate control of spark timing and spark energy for efficient combustion. The MI-07 ignition system provides this control. The system consists of the following components: • SECM • Distributor with ignition module • Ignition coil * • Crankshaft position sensor * • Crankshaft timing wheel * • Spark plugs * The SECM, through use of embedded control algorithms and calibration variables, determines the proper time to start energizing the coil and fire the spark plug. This requires accurate crank/camshaft position information, an engine speed calculation, coil energy information, and target spark timing.

The SECM provides a TTL compatible signal for spark control. The coil must contain the driver circuitry necessary to energize the primary spark coil otherwise an intermediary coil driver device must be provided. The SECM controls spark energy (dwell time) and spark discharge timing. Figure 14. GM Distributor Picture courtesy of Robert Bosch GmbH Figure 15. Throttle Body Assembly Exploded View G643(E) Service Manual Chapter 5. Engine Management System (EMS) 160