Doosan G643 LP Engine — Doosan G643 LP Engine User Manual

Ignition Management SECM Wiring Diagrams for G643E In the normal course of events, with the engine operating at the correct temperature in defined conditions, the SECM will use load and engine speed to derive the correct ignition timing. In addition to load and speed there are other circumstances under which the SECM may need to vary the ignition timing, including low engine coolant temperature, air temperature, start-up, and idle speed control. CAUTION—PROPER WIRING To prevent system faults be sure to follow good wiring practices. Poor wiring may cause unexpe- cted or intermittent failures not related to MI-07 components.

SECM Electrical Mounting Recommendations In order to prevent the possibility of any SECM malfunctions due to EMI/RFI emissions, the SECM mounting and harness recommendations listed below: • The SECM should be mounted in a location that minimizes the amount of EMI the module is exposed to by locating it as far as practical from all high tension components, such as ignition coils, distributors, spark plug wires, etc. It is recommended that the SECM be mounted at least 29.5” (749 mm) away from the distributor and ignition coil, and at least 20” (508 mm) from the nearest plug wire.

• All wiring harnesses should be routed to minimize coupling (both radiated and conducted), and be securely fastened to minimize movement and maintain proper clearance between the SECM and all ignition system components. • The OEM must ensure that a high-quality ground connection between the SECM and battery negative (–) is provided and can be maintained for the useful life of the vehicle. This may require the use of star-type washers on all ground lug connections between the SECM and the battery and/or special preparation of all mating surfaces that complete the ground connection in order to ensure that the connection is sound. G643(E) Service Manual Chapter 5.

Engine Management System (EMS) 166