4. Clean the heavy end deposits from the mixer body with solvent. Be sure the mixer body is completely dry before installing the new air-valve assembly. Replace the air-valve assembly as shown (Figure M7). 5. Place the alignment mark on top of the air valve assembly toward the fuel inlet of the mixer; this places the small notches in the fuel metering valve (fuel cone) inline with the fuel inlet and the large notches of the fuel metering valve “cone”, perpendicular to the fuel inlet of the mixer. Now reinstall the air-valve spring and diaphragm cover (Figure M8). 6. Tighten the cover fastners and reinstall the mixer on the engine (Figure M9). CA100 Disassembled Service 1.
Clean the air valve assembly with soap and warm water to remove heavy-end deposits. Inspect the fuel metering valve and sealing ring for wear. Replace worn components as necessary. Replace all gaskets before assembly. Clean the mixer body (casting) with a parts cleaning solvent. Be sure to remove all seals and gaskets before cleaning the casting with solvent. Make sure all parts are completely dry before re-assembly. NOTE For re-assembly of the CA100 reverse the disassembly steps. WARNING DO NOT spray car carburetor cleaner or solvent into the mixer while installed on the engine. These chemicals may damage the oxygen sensor and cause pre-mature failure of the catalytic muffler.
Figure M7 Figure M8 Figure M9 G643(E) Service Manual Chapter 6. LPG FUEL DELIVERY SYSTEM 221