Regulatory Compliance EPA / CARB Emissions Certification When properly applied and calibrated, ’s MI-07 control system is capable of meeting EPA 2007 LSI emission standards (40 CFR Part 1048.101) when operating properly with an approved three-way catalyst. The emission standards, including appropriate deterioration factors over the useful life of the system, are as follows: HC+NOx: 2.0 g/hp-hr [2.7 g/kW-hr] CO: 3.3 g/hp-hr [4.4 g/kW-hr] Evaporative emissions comply with 40 CFR Part 1048.105. These standards apply only to volatile liquid fuels such as gasoline. Note that the engine crankcase must be closed.
North American Compliance The N-2007 regulator is UL listed per Category ITPV LP-Gas Accessories, Automotive Type. The N-2007 regulator and CA100 mixer have tamper-resistant features approved by CARB. Special Conditions for Safe Use Field wiring must be suitable for at least 248°F (120°C). SECM-48 inputs are classified as permanently connected IEC measurement Category I. To avoid the danger of electric shock, do not use inputs to make measurements within measurement categories II, III, or IV. SECM-48 input power must be supplied from a power supply/battery charger certified to IEC standard with a SELV (Safety Extra Low Voltage) classified output.
SECM-48 inputs and outputs may only be connected to other circuits certified as SELV (Safety Extra Low Voltage). WARNING—EXPLOSION HAZARD Do not connect or disconnect while circuit is live unless area is known to be non-hazardous. Substitution of components may impair suitabil- ity for Class I, Division 2, or Zone 2 applications. Electrostatic Discharge Awareness All electronic equipment is static-sensitive, some components more than others. To protect these components from static damage, you must take special precautions to minimize or eliminate electrostatic discharges. Follow these precautions when working with or near the control. 1.
Before doing maintenance on the electronic control, discharge the static electricity on your body to ground by touching and holding a grounded metal object (pipes, cabinets, equipment, etc.). 2. Avoid the build-up of static electricity on your body by not wearing clothing made of synthetic materials. Wear cotton or cotton-blend materials as much as possible because these do not store static electric charges as much as synthetics. 3.
Keep plastic, vinyl, and Styrofoam materials (such as plastic or Styrofoam cups, cup holders, cigarette packages, cellophane wrappers, vinyl books or folders, plastic bottles, and plastic ash trays) away from the control, the modules, and the work area as much as possible. G643(E) Service Manual 256 Appendix