QSB4.5 and QSB6.7 Lubricating Oil Recommendations and Specifications Section V - Maintenance Specifications Page V-11 An SAE 10W-30 designation on a product is a viscosity designation only. This designation alone does not imply that the product meets Cummins Inc. requirements. Only 10W30 oils with diesel performance credentials listed in table above can be used in Cummins® engines if the reduced ambient temperature indicated in chart above is observed. CAUTION The primary Cummins Inc. recommendation is for the use of 15W-40 multigrade for normal operation at ambient temperatures above -15°C [5°F].
The use of multigrade oil reduces deposit formation, improves engine cranking in low temperature conditions and increases engine durability by maintaining lubrication during high temperature operating conditions. Since multigrade oils have been shown to provide approximately 30 percent lower oil consumption, compared with monograde oils, it's important to use multigrade oils to be certain your engine will meet applicable emissions requirements. While the preferred viscosity grade is 15W-40, lower viscosity multigrades can be used in colder climates. See the accompanying chart.
Oils meeting a 10W30 viscosity grade, must meet a minimum High Temperature/High Shear viscosity of 3.5 cSt., and ring wear/liner wear requirements of Cummins® and Mack™ tests. Thus, they can by used over a wider temperature range than 10W30 oils meeting older API performance classifications. As these oils will have directionally thinner oil films than 15W-40 oils, top quality Fleetguard® filters must be used above 20°C [70°F]. Some oil suppliers might claim better fuel economy for these oils. Cummins Inc. can neither approve nor disapprove any product not manufactured by Cummins Inc. These claims are between the customer and oil supplier.
Obtain the oil supplier's commitment that the oil will give satisfactory performance in Cummins® engines or do not use the oil.