Cummins — 4915973

Coolant Recommendations and Specifications QSB4.5 and QSB6.7 Page V-14 Section V - Maintenance Specifications Coolant Recommendations and Specifications Fully Formulated Coolant/Antifreeze Cummins Inc. recommends the use of fully formulated antifreeze/ coolant meeting Cummins Engineering Standards (C.E.S.) 14603. For further details and discussion of coolant for Cummins® engines, refer to Coolant Requirements and Maintenance, Bulletin 3666132. Typically, antifreeze/coolants meeting ASTM4985 (GM6038M specification) or ASTM D6210 criteria are acceptable antifreeze/ coolants for engines covered by the manual.

Low-silicate antifreeze/coolants meeting ASTM D4985 (GM6038M specification) are not adequate for extended service intervals. Cummins Inc. recommends using either a 50/50 mixture of good- quality water and fully formulated antifreeze, or fully formulated coolant when filling the cooling system. Good-quality water is important for cooling system performance. Excessive levels of calcium and magnesium contribute to scaling problems, and excessive levels of chlorides and sulfates cause cooling system corrosion. Water Quality Calcium Magnesium (hardness) Maximum 170 ppm as (CaCO3 + MgCO3) Chloride 40 ppm as (CI) Sulfur 100 ppm as (SO4)