Komatsu — OTHER DISPLAY MESSAGES

OM6008 Optional Equipment - Section 6 Payload Meter 3 Page 6-9 Total Load Counter The Total Load Counter records the number of loads hauled since the last time it was cleared. This display can be cleared at the beginning of each shift to allow the operator to record how many loads have been hauled during the shift. The inclinometer displays whole degrees of incline. Positive incline is truck nose up. The gauge will quickly display the type of information shown every 10 seconds. For example, if the left-front pressure is being displayed, will flash on the display every minute. Only the payload display, does not display this information.

Left Front Pressure - To display the pressure in the left-front suspension, press and release the To view the Total Load Counter press and release the “SELECT” switch until is displayed on the gauge. “SELECT” switch until is displayed. Right Front Pressure - To display the pressure in the right-front suspension, press and release the Clearing the Counters Clearing the Total Ton Counter or Total Load Counter clears both records. “SELECT” switch until is displayed. Left Rear Pressure - To display the pressure in the left-rear suspension, press and release the To clear the total ton and total load counter: 1. Press the “SELECT” switch until or is displayed. “SELECT” switch until is displayed.

Right Rear Pressure - To display the pressure in the right-rear suspension, press and release the “SELECT” switch until is displayed. Inclinometer - To display the truck incline, press 2. Hold the “SET” button until the display clears. and release the “SELECT” switch until is displayed. Viewing Live Sensor Data The display can also be used to quickly show the current readings from the four suspension pressure sensors and the inclinometer. This can be used during regularly scheduled service periods to check the state of the suspensions. These displays are live and will update as the values change.

Other Display Messages On startup of the payload meter system, the gauge display will scroll the truck type that the PLM3 is configured for. For example, on a 930E, the gauge The live displays cannot be cleared and the SET button will have no effect. will scroll, The units for the display are controlled by the configuration of the payload meter. If the payload meter is set to display metric units, the pressures will be displayed in tenths of kg/cm 2 . For example, if the If the PLM3 encounters memory problems, it will display where 88 is the specific memory error. In this very rare circumstance, the system should be turned off for 30 seconds and restarted.

display shows the actual value is 20.2 kg/ cm 2 . If the payload meter is set to display short tons, the pressures will be displayed in psi (lbs/in2). To convert from kg/cm 2 to psi, multiply by 14.2. 1 1kg/ cm 2 = 14.2 psi. There is no way to detect the units setting for the gauge without the PC software.