Operation - Section 3 OM3029.3 9/01 Page 3-40 Instrument Panel & Indicator Lights A5. NO POWER This RED “No Retard/No Propel” indicator light indicates a fault has occurred which has eliminated the retarding and propulsion capability. A warning buzzer will also sound. If this condition occurs, the operator should safely stop the truck, move Selector Switch to Neutral, apply the Park Brake, shutdown engine, and notify maintenance personnel immediately. B5. PROPULSION SYSTEM WARNING When this amber indicator is illuminated, the light indicates a “No Propel” or “No Retard” event may be about to occur. It is intended to provide advance notice of these events when possible.
It does not require the operator to stop the truck, but may suggest that truck operation be appropriately modified, in case a red alarm does occur. This amber AC Drive System “Temperature Warning” light indicates the drive system temperature is above a certain level. When this condition occurs, the operator should consider modifying truck operation in order to reduce system temperature. The operator is not required to stop the truck at this time. C5. PROPULSION SYSTEM TEMPERATURE D5. HIGH HYDRAULIC OIL TEMPERATURE This red warning light indicates high oil temperature in the hydraulic tank. Several things occur before the red light illuminates:
If the truck is moving, and the oil temperature exceeds 221° F (105° C), the minimum idle speed will be 1200 RPM (normally 1050). If the truck is moving, and the oil temperature goes above 230° F (110° C), the minimum idle speed will be 1700 RPM (normally 1050). If the truck is stopped, and the oil temperature goes above 212° F (100° C) the minimum idle speed will be 1000 RPM (normally 750). NOTE: Once the oil cools down to the normal operating range, the engine RPM will return to normal speed. The red warning light will illuminate if the oil temperature rises above 248° F (120° C). Continued operation could damage components in the hydraulic system.
If this condition occurs, the operator should safely stop the truck, move Selector Switch to Neutral, apply the Park Brake, and operate engine at 1200 - 1500 RPM to reduce system temperature. If temperature gauge (25, Figure 3-7) does not move into the Green range after a few minutes, and the RED overhead indictor light does not go out, notify maintenance personnel imme- diately.