Komatsu — CHECK AIR CONDITIONER COMPRESSOR BELT TENSION, ADJUST

. MAINTENANCE SERVICE PROCEDURE CHECK AIR CONDITIONER COMPRESSOR BELT TENSION, ADJUST CHECKING air conditioner thumb (about initial elongation, so adjust the belt 4 - 48 Pres compressor pulley (1 58.8 N {6 kg}). 58.8 If deflection (A) is 10 mm, the belt tensio n is norm ADJUSTING 1. Loosen bolt (1). 2. Turn nut (2) to a (0.4 in) when p between the air c of approx. 58.8 N 3. Tighten bolt (1) position. 4. Check each pulle of the V-belt. In p touching the bott 5. If the V-belt is s more or if it has 6. If the V-belt has operating for 2 to djust so that the belt deflects approx. 10 mm 1. L 2. T ( b o 3. T p 4. C o t 5. I 6. I o 1. L 2. T urn nut (2) to a deflects approx.

1 0 mm 0.4 in) when p ressed with the thu mb at a point mi dway etween the air c ompressor pulley an d drive p ulley with a force f approx. 58.8 N (6 kg). and nut (2) to secure the compressor in 3. T ighten bolt (1) osition. 4. C heck each pulle y for damage, wear o f the V-groove, and wear f the V-belt. In p articular, be sure to c heck that the V-belt is not ouching the bott om of the V-groove. 5. I f the V-belt is s o lengthened that it more or if it has any cuts or cracks, r eplace it. 6. I f the V-belt has perating for 2 to again afte