OPERATION NORMAL OPERATING INFLATION PRESSURE Measure the tire pressure before starting operations, when the tires are cool. If the inflation pressure is too low, it causes overload on the tires; if the inflation pressure is too high, the tire may be cut or may burst under shock. Therefore adjust the inflation pressure to the values in the following table.
Inflation Pressure Tire Size and Type Soft or Sandy Ground Normal Ground Stockpiling Digging 26.5 x 25 - 20 ply L3 Front 4.5 kg/cm* (64.0 psi) 26.5 x 25 - 20 ply L4 Rear 3.5 kg/cm* (49.8 psi) 3.0 - 4.0 kg/cm* 3.5 - 4.5 kg/cm* (42.7 - 56.9 psi) (49.8 - 64.0 psi) 3.5 - 4.5 kg/cm* (49.8 - 64.0 psi) 26.5 x R25 XHATI L3 I Front 4.5 kg/cm* 3.0 - 4.0 kg/cm* (42.7 - 56.9 psi) 3.5 - 4.5 kg/cm* (49.8 - 64.0 psi) 3.5 - 4.5 kg/cm* (49.8 - 64.0 psi) 29.5 x 25 - 22 ply L3 Front 4.5 kg/cm* (64.0 psi) 29.5 x 25 - 22 ply L4 Rear 3.5 kg/cm* (49.8 psi) 3.0 - 4.0 kg/cm* (42.7 - 56.9 psi) 3.5 - 4.5 kg/cm* (49.8 - 64.0 psi) 3.5 - 4.5 kg/cm* (49.8 - 64.0 psi) 29.5 x 25 - 22 ply L5 29.5 x R25 XHATI L3 Front 4.5 kg/cm* (64.0 psi) 3.0 - 4.0 kg/cm* (42.7 - 56.9 psi) 3.5 - 4.5 kg/cm* (49.8 - 64.0 psi) 3.5 - 4.5 kg/cm* (49.8 - 64.0 psi) 29.5 x R25 XRD Rear 3.5 kg/cm* (49.8 psi) INFLATING TIRES Connect an air hose to air supply coupling (1) to inflate the tires.
l For operations on normal road surfaces, rock digging operations . . High end of range in inflation pressure chart l Stockpile operations on soft ground . . . Average pressure in inflation pressure chart l Operations on sand and operations not using much digging force .._ Low end of range in inflation pres- sure chart 2-63