Komatsu — ENGINE OIL LEVEL

MAINTENANCE CHECKS BEFORE STARTING ENGINE WALK AROUND CHECK Perform a walk around check of the machine as outlined in Section 2. COOLANT LEVEL A WARNING! Do not remove radiator cap (1) when the engine coolant is hot. Hot coolant may spout out and cause seriuos personal injury. When removing radiator cap, lift the safety lever to relieve the system inner pres- sure. Remove radiator cap (1) and strainer from the radiator filler opening and check the coolant level. The coolant should be up to the level as indicated by the shadowed portion in the illustration. If not, add coolant as neces- sary. === is= - e ==i z-z =iz =z= =is =I= --- /T --- ===L06AMolc Do not add cold coolant to a hot engine.

Engine damage may result. Allow the engine to cool below 50°C (120°F) before adding coolant. * * If the volume of coolant added is more than usual, check for possible leakage. * Confirm that oil is not present in the coolant. * Never use a sealing additive to stop leaks in the cooling system. This can result in cooling system plugging and inadequate coolant flow. LO6AMOli ENGINE OIL LEVEL 1. Open the engine side cover located on the left rear side of the machine. 2. Use dipstick (G) to check the oil level. 3. The oil level should be between mark L and H, if necessary, add oil at oil filler (F).

* When checking the oil level, park the machine on a level surface and make an oil level check before starting the engine or 5 minutes or more after the engine is stopped. 3-39