SAFETY PRECAUTIONS 1. Cautions when starting the machine 3. Caution for engine fan and belts I. WHEN STARTING THE MACHINE OR WHEN TRAVELING OBSERVE THE FOLLOWING. (1) WHEN WITH BACK-HOE WITHDRAW OUTRIGGER PERFECTLY. (2) CHECK EACH GAUGE AND PILOT LAMP. (3) RELEASE PARKING BRAKE AND START MACHINE. (4) USE PARKING BRAKE ONLY AFTER MACHINE HAS STOPPED COMPLETELY, EXCEPT IN EMERGENCIES. (5) WHEN DESCENDING A SLOPE TRAVEL AT A SPEED SUFFICIENT TO ASCEND THE SLOPE, AND DO NOT SET THE GEARSHIFT LEVER IN NEUTRAL. !. WHEN CARRYING OUT MAINTENANCE: (11 PARK THE MACHINE ON LEVEL . , GROUND. (2) LOWER WORK EQUIPMENT ON THE GROUND AND LOCK THE LEVER.
(3) 60 NOT GO UNDER MACHINE WHEN IT IS RAISED BY THE WORK EQUIPMENT. L02ADO47 4. Warnings for machine operation READ THE OPERATION & MAINTENANCE MANUAL FOR SAFETY OPERATION AND ALWAYS PAY &biXIMlJM AlTENTlON FOR SAFETY. I. WHEN STARTING THE ENGINE OR LEAVING THE MACHINE, ANYTIME FOLLOW THE PROCEDURE DESCRIBED BELOW. (1) PLACE THE DIRECTION LEVER IN NEUTRAL POSITION (N). (2) APPLY THE PARKING BRAKE. (3) LOWER THE BUCKET (OR THE FORKS, ETC.) TO THE GROUND AND APPLY THE CONTROL LEVER LOCK. (4) STOP THE ENGINE. (IDLE THE ENGINE FOR 5 MUNUTES PRIOR TO SHUT DOWN) 2. WHEN PARKING AT INCLINED PLACE, ADDING TO THE ABOVE DESCRIBED, APPLY THE WHEEL STOPPERS FOR BOTH WHEELS (FRONT OR REAR). L02AD045 2.
Warning for frame locking bar rllAKE SURE OF SETTING THE ARTICULATE _OCK TO FIX THE FRONT/REAR FRAMES Y THE FOLLOWING CASES. 1. INSPECTION AND MAINTENANCE IN THE CENTER OF THE VEHICLE AND 421-93-11940 L02AD048 ITS VICINITY. 2. TRANSPORTING VEHICLE. 3. HOISTING VEHICLE. IEFORE START A DRIVE MAKE SURE OF IISCONNECT ARTICULATE LOCK. L02AD046 1-16