Komatsu — AIR CONDITIONER SWITCH

OPERATION CAB HEATER, DEFROSTER AND AIR CONDITIONER - IF EQUIPPED CONTROL PANEL It is possible to use the cab heater and air conditioner to good effect in dusty jobsites. The outside air is passed through the filter and is sent to the operators cab to increase the pressure inside the cab. In this way, dust is prevented from entering, so comfortable operating conditions are always maintained for the operator. 1. FAN SPEED SWITCH This switch controls the air flow when the cab heater and air conditioner is used for heating or cooling. * It has three air flow control levels: LO (Low), ME (Medium) and HI (High) * If the outside air is extremely dusty, set the fan speed switch to the HI position.

This will pressurize the cab and prevent the dust from entering. 2. TEMPERATURE CONTROL KNOB This knob is used to control the temperature for cooling or heating. 0 4 L13FD064 * The farther the knob is moved to counter-clockwise, the lower the temperature of the air blown out from the vents. * The farther the knob is moved to clockwise, the higher the temperature of the air blown out from the vents. 3. AIR INTAKE SELECTOR KNOB This knob switches the air intake port when cooling or heating. * FRESH: Operate the knob clockwise. Fresh air is taken in from outside in addition to the air inside the compartment.

This is used for ordinary heating or cooling and when pressurizing the inside of the cab. * RECIRC: Operate the knob counter-clockwise. Only air inside the compartment is used. This is mainly used for quick heating or cooling. 4. AIR CONDITIONER SWITCH This switch turns the air conditioner on and off. ON: Depress the switch to start dehumidification and cooling. 2-36