Komatsu — 10 HOUR (DAILY) INSPECTION

Lubrication & Service - Section 40 OM4036 Page 40-4 10 HOUR (DAILY) INSPECTION 8. Truck Serial Number Site Unit Number Date ______________________ _______________ _______________ Hourmeter Name of Service Technician _____________ ___________________________________ TASK COMMENTS CHECKED INITIALS MACHINE - Inspect the entire machine for leaks, worn parts, and damage. Repair as necessary. FAN DRIVE AND TURBOCHARGERS - Check for leaks, vibration or unusual noise. Check alternator and fan belt condition and alignment. RADIATOR - Check the coolant level and fill with the proper mixture as shown in the Cooling System Rec- ommendation Chart in this chapter.

Refer to the engine manual for proper coolant additives. ENGINE - a. Check the oil level on the dipstick. Refer to the engine manual for oil recommendations. (Lube Key “A”). NOTE: If the truck is equipped with a reserve engine oil tank, the oil should be visible in the center (middle) sight gauge. If not, add oil to the reserve tank until oil is visible in the top sight gauge. Also, with the engine running, check operation of the LED indicator light. See below for description of LED light signals. Refer to Figure 40-1. LED Light Signals: • Steady - Pump 1 is withdrawing oil from the engine sump and bringing down the oil level.

• Regular pulsing - Pump 2 is returning oil to the engine sump and raising the oil level. • Irregular pulsing - Oil is at the correct running level. b. Inspect exhaust piping for security. c. Check for abnormal noises and fluid leaks. HYDRAULIC TANK - Check the oil level in the tank; add oil if necessary. Refer to Section L, Hydraulic Tank - Filling Instructions. Oil should be visible in the sight glass. - Do Not overfill. Lube Key “B”. BATTERIES - Check the electrolyte level and add water if necessary. WHEELS AND TIRES - a. Inspect tires for proper inflation and wear. b. Check for embedded debris in tread and remove. c. Inspect for damaged, loose, or missing wheel mounting nuts and studs.

COOLING AIR DUCTWORK - Inspect ductwork from the blower to the rear drive case. Ensure that duct- work is secure, free of damage, and unrestricted.