Automatic Lubrication System - Section 42 OM4200 Page 42-6 GENERAL INSTRUCTIONS Required Lubricant For System Grease requirements will depend on ambient tem- peratures encountered during truck operation: Above 90°F (32°C) - Use NLGI No.2 multipurpose grease (MPG). -25° to 90°F (-32° to 32°C) - Use NLGI No. 1 multipurpose grease (MPG). Below -25°F (-32°C) - Refer to local supplier for extreme cold weather lubricant requirements. System Priming The system must be full of grease and free of air pockets to function properly. After maintenance, if the primary or secondary lubrication lines were replaced, it will be necessary to re-prime the system to eject all entrapped air. 2.
To purge air from the main supply line, remove the main supply line at the Lincoln Lube canis- ter and connect an external grease supply to the line. 1. Fill lube reservoir with lubricant, if necessary. 3. Remove plugs from each injector group in sequence (right front, left front, and rear axle). 4. Using the external grease source, pump grease until grease appears at the group of injectors and re-install the pipe plug. Repeat for remain- ing injector groups. 5. Remove the caps from each injector and con- nect an external grease supply to the zerk on the injector and pump until grease appears at the far end of the individual grease hose or the joint being greased. FIGURE 42-5.
FILTER ASSEMBLY 1. Housing 2. Bypass Indicator 3. O-Ring 4. Backup Ring 5. Element 6. Spring 7. Bowl 8. O-Ring 9. Plug Filter Assembly The filter assembly element (5, Figure 42-5) should be replaced if the bypass indicator (2) shows exces- sive element restriction.