Automatic Lubrication System - Section 42 OM4200 Page 42-10 SYSTEM CHECKOUT To check system operation (not including timer), pro- ceed as follows: 1. Turn keyswitch ON and start the engine. 2. Actuate the lube system test switch at the reser- voir/pump assembly on the front bumper. 3. The motor and pump should operate until the system attains 2500 psi (17 237 kPa). 4. Once the required pressure is achieved, the pump motor should turn off and the system should vent. 5. Check for pump, hose or injector damage or leakage with the system under pressure. 6.
After checking system, shutdown engine, observing normal precautions regarding high voltage present in the propulsion system before attempting to repair lube system. FIGURE 42-8. TIMER (TOP COVER REMOVED) Lubrication Cycle Timer Check 1. Timer Enclosure 2. Red LED (Light Emitting Diode) 3. Timer Selector To check the solid state timer operation without wait- ing for the normal timer setting, proceed as follows: 1. Remove timer dust cover. Lubrication Cycle Timer Adjustment NOTE: The timer incorporates a liquid and dust tight cover which must be in place and secured at all times during truck operation. The timer is factory set for a nominal 2.5 minute (off time) interval.
Dwell time is approximately 1 minute, 15 seconds. A longer interval (off time) is obtained by turning the selector knob (3, Figure 42-8) to the desired position. 2. Adjust timer selector (3, Figure 42-8) to 5 minute interval setting. 3. The timer should cycle in five minutes if the truck is operating. NOTE: Set timer by turning the selector knob (3) to the 2.5 minute setting point. Then, turn the Selector clockwise, one detent at a time, to the desired setting, or until the maximum limit of eighty minutes is reached. NOTE: If the timer check is being made on a cold start, the first cycle will be approximately double the nominal setting.
All subsequent cycles should be within the selected time tolerance. 4. Voltage checks at the timer should be accom- plished if the above checks do not identify the problem. The timer is a sealed unit, do not attempt disas- sembly. a. Insure timer ground connection is clean and tight. b. Using a volt-ohm meter, read the voltage between positive and negative posts on the solid state timer with the truck keyswitch ON. Normal reading should be 18-26 VDC, depending upon whether or not the engine is running.