Cab Radio - Section 70 OM7003 Page 70-4 BALANCE: Push and release ON/AUDIO (6) knob until "BAL" and the present level is displayed. Rotate the knob clockwise to move the sound to the front speakers and counter-clockwise to move the sound to the rear speakers. Playing A Cassette 1. Turn the receiver ON. 2. Insert a cassette into the player. The cassette icon will appear on the display. The tape will begin to play when the icon appears. SPEAKER: Push and release ON/AUDIO (6) knob until "SPKR" and the current setting is displayed. Rotate the ON/AUDIO knob to select 2-speaker or 4- speaker operation.
When 2-speaker operation active, the rear speakers are muted and the FADE option will not appear on the menu. NOTE: Press button (3) to change from the radio to a cassette. "TP SIDE 1" or "TP SIDE 2" will appear on the display depending on which side of the cassette is currently being played. If a cassette is not loaded in the player, "NO TAPE" will appear on the display. PROGRAMMABLE EJECT DEFAULT The cassette player has been pre-programmed to return to the radio after a tape has been ejected. This default may be changed to an “eject audio mute” mode. This mode will mute the radio after a cassette has been ejected.
When this occurs, “NO TAPE” will appear on the display and the radio will remain muted until BAND (2) is pressed. Pressing this button will enable the radio. Cassette Functions 4/REV (17): This button rewinds the cassette. The cassette will continue to rewind until the button is pressed again, or until the cassette reaches the end of the tape. " cassette is rewinding. 6/FF (15): This button fast forwards the cassette. The cassette will continue to fast forward until the button is pressed again, or until the cassette reaches the end of the tape. "FWD>" will appear on the display as Perform the following steps to change the eject default mode: 1.
Press and hold DSP/TM SET (9) for at least 2 seconds until the hour digits flash. 2. Press button (3) to toggle between “P.PLAY” and “EJMUTE”. After 5 seconds of inactivity, the receiver will return to the default display. Press this button to eject the cassette from the player. When the eject button is held, it acts This button causes the cassette player to reverse directions and play the opposite side of the cassette. Pressing the button a second time will reverse the cassette back to the original side. CASSETTE PLAYER The cassette player that the radio is equipped with works best with cassettes that range from 30 to 90 minutes long.
Cassettes that are longer than 90 min- utes have thinner tape, and do not work well in this model cassette player. NOTE: The cassette will automatically flip to the opposite side when the end of the tape is reached. It is also important to only use cassettes that are in good condition. Cassettes that are dirty, damaged, or have been exposed to excessive heat and/or sunlight could cause damage to the cassette player and pos- sible failure. The cassette player is equipped with automatic equalization and metal tape sensing functions. An "M" will appear on the display when a metal tape is sensed. Cleaning the cassette player is a recommended maintenance item.
It should be performed at 35 hour (cassette play) intervals. Failure to clean the cassette player may diminish sound quality and cause cas- sette player failure. the casse Eject ( from the as a stop t 5 from the as a stop pl b (4): Th reverse dir cassette. reverse th (4): Th