Safety - Section 20 OM2030 Page 20-6 In Operator’s Cab - Before Starting The Engine Do not leave tools or spare parts lying around or allow trash to accumulate in the cab of the truck. Keep all unauthorized reading material out of the truck cab. Keep the cab floor, controls, steps, and handrails free of oil, grease, snow, and excess dirt. Check the seat belt, buckle and hardware for damage or wear. Replace any worn or damaged parts. Always use the seat belts when operating a machine. Read and understand the contents of this manual. Read Sections 30 and 32 pertaining to safety and operating instructions with special attention.
Become thoroughly acquainted with all gauges, instruments and controls before attempting operation of the truck. Read and understand the WARNING and CAUTION decals in the operator's cab. Ensure the steering wheel, horn, controls and pedals are free of any oil, grease or mud. Check operation of the windshield wiper, condition of wiper blades, and check the washer fluid reservoir level. Be familiar with all steering and brake system controls, warning devices, road speeds and loading capabilities, before operating the truck. Mirrors, Windows, And Lights Remove any dirt from the surface of the windshield, cab windows, mirrors and lights. Good visibility may prevent an accident.
Adjust the rear view mirror to a position where the operator can see best from the operator's seat. If any glass or light should break, replace it with a new part. Ensure headlights, work lights and taillights are in proper working order. Ensure that the machine is equipped with the proper work lamps needed for the operating conditions. OPERATING THE MACHINE When Starting The Engine Never start the engine if a warning tag has been attached to the controls. When starting the engine, sound the horn as an alert. Start and operate the machine only while seated in the operator’s seat. Do not allow any unauthorized persons in the operator's compartment or any other place on the machine.
Truck Operation - General Wear seat belt at all times. Only authorized persons are allowed to ride in the truck. Riders must be in the cab and belted in the passenger seat. Do not allow anyone to ride on the decks or steps of the truck. Do not allow anyone to get on or off the truck while it is in motion. Do not move the truck in or out of a building without a signal person present. Know and obey the hand signal communications between operator and spotter. When other machines and personnel are present, the operator should move in and out of buildings, loading areas and through traffic, under the direction of a signal person. Courtesy at all times is a safety precaution!
Immediately report any adverse conditions at the haul road, pit or dump area that may cause an operating hazard.