Komatsu — Engine Shutdown Switch with 5 Minute Idle Timer Delay

OM3202 Operator Cab And Controls - Section 32 Page 32-15 PANEL GAUGES, INDICATORS, AND CONTROLS (Figure 32-7) Key Switch Key switch (1, Figure 32-7) is a three position (OFF, RUN, START) switch. Starting When the switch is rotated one position clockwise, it is in the RUN position and all electrical circuits (except START are activated. 1. With selector switch in NEUTRAL, rotate keyswitch fully clockwise to START position, and hold this position until engine starts. START position is spring-loaded to return to RUN when key is released. 2. After engine has started, place rest switch in OFF position (de-activate the "rest" mode of operation).

Refer to discus- sion of rest switch (26, Figure 32-7). Engine Shutdown Switch with 5 Minute Idle Timer Delay The timer delayed, engine shutdown switch (2, Figure 32-7) is a 3-position, rocker type switch with OFF, ON and MOMENTARY positions. When used, the engine is allowed to idle for approximately 5 minutes before actual shutdown occurs. The delayed shutdown feature allows the engine to cool down slowly, reducing internal temperatures as coolant is circulated through the engine. Operation 1. Stop the truck, and reduce engine rpm to low idle. Place the selector switch in NEUTRAL and apply the park- ing brake switch.

Place the rest switch in ON position (put drive system in "rest" mode of operation). Refer to the discussion of the rest switch later in this chapter. 2. Press the top of the engine shutdown switch to select the ON (center) position. Press the top of the switch again to activate the timer delay (MOMENTARY position). Release the switch and allow it to return to the ON position. When the engine shutdown timer has been activated, the timer delay indicator light (C4, Figure 32-8) in the overhead status panel will illuminate to indicate that the shutdown timing sequence has started. The engine will continue to idle for approximately 5 minutes to allow for proper engine cool-down before stopping.

3. Turn the keyswitch counterclockwise to the OFF position to cause the engine to shutdown when the timing sequence is complete. When the engine stops, this will activate the hydraulic bleeddown timer and turn off the 24 VDC electric circuits controlled by the keyswitch. NOTE: To cancel the 5 minute idle timer sequence, press the timer delay shutdown switch to the OFF (lower) position. If the keyswitch is in the OFF position, the engine will stop. If the keyswitch is in the ON position, the engine will continue to run. 4. With keyswitch OFF, and engine stopped, wait at least 90 seconds.

Ensure the steering circuit is completely bled down by turning the steering wheel back and forth several times. No front wheel movement will occur when hydraulic pressure is relieved. 5. Verify all the link voltage lights turn off within 5 minutes after the engine is shut down. (One is located in the cab behind the operator seat, two others are located in the access panel at the left front corner of the electri- cal cabinet. If the lights remain on, refer to Section E in the service manual for additional instructions and information. 6. Close and lock all windows, remove key from keyswitch and lock cab to prevent possible unauthorized truck operation. Dismount the truck properly.

position, rocker type switch gine is allowed to idle for ed shutdown feature allows coolant is circulated through