Komatsu — Tachometer

OM3202 Wheel Brake Lock Control service brakes only sure! brakes to release! Parking Brake Control The parking brake is spring applied and hydraulically released. It is designed to hold a stationary truck when the engine is shutdown and keyswitch is turned OFF. The truck must be completely stopped before applying the parking brake, or damage may occur to parking brake. To apply the parking brake, press parking brake control switch (13, Figure 32-7) toward the ON symbol. To release the parking brake, press the switch toward the OFF symbol. When the keyswitch is ON and parking brake switch is applied, the parking brake indicator light (A3, overhead panel, Figure 5-8) will be illuminated. NOTE:

Do not use the parking brake at shovel or dump. With keyswitch ON and engine running, sudden shock caused by loading or dumping could cause the system's motion sensor to release the park brake. Tachometer Tachometer (14, Figure 32-7) registers engine crankshaft speed in hundreds of revolutions per minute (rpm).

Governed rpm Low Idle - 600 rpm High Idle - 1900 rpm Full Load - 1910 rpm Operator Cab And Controls - Section 32 Page 32-17 2-7) should be used with engine running for dumping and loading actuates the hydraulic brake system which locks the rear wheel o shovel or dump area, stop the truck using the foot-operated ser- pletely stopped and in loading position, apply the brake lock by ON symbol. To release, press the rocker switch toward the OFF symbol. d truck in position. k, unless foot-oper- Use of this switch unmodulated pres- king. With engine eed down, allowing