. OPERATION DETAILED CONTROLS AND GAUGES 3 - 74 Emergency Pump Drive S witch to enable you to carry out operation temporarily, when any problem occurs on the pump control ept in emergency. Furthermore, remove the cause of the problem immediately. NOTICE This switch is provided when system. Do not use it exc ept in emergency. Furthermore, rem ove the cause of the problem immediately If this switch is depresse d and moved to the EMERGENCY po sition by mistake, thereby engaging the machine in the work while the machine is in n If "E02" is displayed duri ormal condition, an "E02" mark is sh own in th e display.
ng the work, check that the switch is in the NORMAL position This switch (9) is used to make it possible to carry out op erations temporarilyif any problem should occur in the pump control system (when the display shows "E02"). If the display shows "E02 ", move the switch up to make it p ossible to carry out work. Swing Brake Cancel Swit ch NOTICE This switch makes it possib le to perform swing operations for a short tim e even when there is a problem in the swing p arking brake electric system. DO N OT use this switch except in emergen cies. Repair the problem as soon as pos sible.
This switch (10) is used t o make it possible to carry out op erations temporarily if any problem should occur in the swing brake system (when the upper structur e does not swing but the display d oes not show "E03"). If the display does not show "E03", move the switch up t o FREE position (a) to make it possible to carry out work. When the switch is m oved to FREE position (a), the sw ing lock monitor flashes. Revolving Warning Lamp Switch (If equipped) Use this switch (11) to lig ht up the yellow rotating lamp on to p of the cab. (a) ON: Lamps light up (b) OFF: Lamps go off