Komatsu — BEFORE STARTING ENGINE

. OPERATION MACHINE OPERATIONS AND CONTROLS Check Coolant Level, Add Coolant WARNING 3 - 119 Do not open th e radiator cap unless necessa ry. When checking th e coolant, alway s wait f or the engine to c ool down and check the sub-tank. Immediately af ter the engine is stopped, the coolant is at a high te mperatur e and t he radiator is under hig h internal pressure. If the cap is re moved to check the coolant l evel in this condition, there is a hazar d of b urns. Wait for th e temperature to go down, then tur n the cap slowly to release th e pressure and remov 1.

Open the do or at the rear left of the m achine, and check i f the coolant in s ub-tank (1) (shown in the diagram on the rig ht) is between the FULL and LOW marks. If the coolant level is low, add coolant to the FULL level through the filler port of sub-tank (1). coolant, tighten the cap securely. ank becomes empty, there is probably coolant 2. After adding coolant, tighten the cap s 3. If the sub-t ank becomes empty, the olant leakage. Aft er checking, repair any ab normality immediate ly. If no abnorma lity is found, check the l t is low, add COOLANT evel of the water in the of the same density in density table in "CLEAN the radiator.

If i ty in radiator acc ording to the COOLANT INSIDE OF COOLING SYSTEM (P to the sub-tank. AGE 4-27)", then add add COOLANT 4. If the inside of sub-tank (1) is dirty an d the water level cannot be seen, us SYSTEM (P e the procedure in "CLEAN AGE 4-27)". INSIDE OF COOLING