Komatsu — MAINTENANCE INFORMATION

. MAINTENANCE MAINTENANCE INFORMATION MAINTENANCE INFORMATION Service Meter Reading Check the service meter reading every day to see if the time has come for any necessary maintenance to be performed. Komatsu Genuine Lubricants For lubrication of the machine, use the Komatsu genuine lubricants. Moreover use oil of the specified viscosity according to the ambient temperature.

4 - 2 Do not perform any i nspection and maintenance op eration that is not fo Komatsu Genuine Re placement Parts Use Komatsu genuin e parts specified in the Parts B ook as replacemen Windshield Washer F luid Use automobile wind ow washer fluid, and be carefu l not to let any dirt g Fresh and Clean Lub ricants Use clean oil and gre ase. Also, keep the containers of the oil and greas e clean. Keep foreign materials a way from oil and grease. Check Drained Oil an d Used Filter After oil is changed o r filters are replaced, check the o ld oil and filters for m etal particles and for eign material s. If l arge quantity of metal pa suitable action.

rticles or foreign materials are found, always report to the person in charge, and carry out harge, carry Fuel Strainer If your machine is eq uipped with a fuel strainer, do n ot remove it while f Welding Instructions ait for approximately. 1 minute after turning off the engine starting switch key, and then gative (-) terminal of the battery. than 200 V continuously. g cable within 1 m (3.3 ft) of the area to be welded. If grounding cable is connected near ectors, etc., the instruments may malfunction. Cut off power. W disconnect the ne gative (-) terminal of the battery Do not apply more than 200 V continuously.

g cable within 1 m (3.3 ft) of t Connect groundin instruments, conn ectors, etc., the instruments ma y malfunction. If a seal or bearing happens to come between the part being welded a nd grounding point, change the g rounding point to avoid suc h parts. ea around the work equipment pins or the hydraulic cylinders as the grounding point. Do not use the ar ea around the work equipment p ins or the hydraulic cylinders as the gro unding point Do not Drop Things I nside Machine When opening ins pection windows or the oil filler port of the tank to c arry out inspection, be careful n ot to drop nuts, bolts, or tool If such things are lead to failure. If y s inside the machine.

dropped inside the machine, it m ay cause damage and/or malfunction of the machine , an d will ou drop anything inside the ma chine, always remo ve it immediately. r inspection. Do not put unnece ssary things in your pockets. C arry only things wh ich are necessary fo r inspection.