. MAINTENANCE OUTLINE OF SERVICE 4 - 5 FUEL To prevent the moisture in th e air from condensing and forming water inside the fuel tank, always fill the fuel tank after completing the day's w ork. instrument, and if fuel containing water or dirt is used, it cannot work properly. let impurities get in when storing or adding fuel. d for the temperature in the Operation and Maintenance Manual. The fuel pump is a precision instrument, and if fuel containing water or dirt is used, it cannot work pro Be extremely careful not to let impurities get in when storing or adding fuel.
Always use the fuel specifie d for the temperature in the Operation and Mai If the fuel is used at temp °C (5°F), the fuel will soli If the fuel is used at temp result in problems such a If the fuel is used at temp eratures lower than the specified temperature (p articularly at temperatures below -15 dify. If the fuel is used at temp eratures higher than the specified temperature, the viscosity will drop, and this may s a drop in output. Before starting the engine, o r when 10 minutes have passed after adding fue l, drain the sediment and w ater from the fuel tank. If the engine runs out of fuel , or if the filters have been replaced, it is neces sary to bleed the air from th e circuit.
If there is any foreign mater ial in the fuel tank, wash the tank and fuel syste m. NOTICE Always use diesel oil for the fuel. To ensure good fuel consumption characteristics and exhaust gas characteristics, the e ngine mounted on this machi ne uses an electronically controlled high-pres sure fuel injection device. This device requires high precision parts and lubrication , so if low viscosity fuel with low lubricating ability is used, the durability may drop markedly. COOLANT AND WATER F OR DILUTION OOLANT (AF-NAC) has the important function of preventing corrosion as well as ezing is not an issue, the use of antifreeze COOLANT is essential. Komatsu genuine SUPERC preventing freezing.
Even in the areas where fre ezing is not an issue, the use of antifreeze CO Komatsu machines are supp lied with Komatsu SUPERCOOLANT (AF-NAC ). SUPERCOOLANT (AF- NAC) has excellent anticorrosion, antif reeze and cooling propertiesand can be used co ntinuously for 2 years or 40 00 hours. As a basic rule, we do not re commend the use of any COOLANT other than SUPERCOOLANT (AF-NA C). If you use another COOLANT, it m ay cause serious problems, such as corrosion of the engine and aluminu m parts of the cooling system. ays observe the precautions given in the Operation and Maintenance Manual. d with distilled water, so it is not flammable. OLANT differs according to the ambient temperature.
the COOLANT, see "CLEAN INSIDE OF COOLING SYSTEM (PAGE 4-27)". When using antifreeze, alw ays observe the precautions given in the Opera tion and Maintenance Man COOLANT is already dilute d with distilled water, so it is not flammable. The density used for the CO OLANT differs according to the ambient tempe For details of the density of the COOLANT, see "CLEAN INSIDE OF COO LING SYSTEM (PAGE 4-2 Even in the areas where it is not considered necessary to prevent freezing, a lways use COOLANT with a density of over 30% in order to prev ent corrosion of the cooling system. stilled water that does not contain any ions or water-hardening substances. Never dinary water.
t for the engine to cool before adding coolant. COOLANT is diluted with di dilute the COOLANT with or If the engine overheats, wai If the coolant level is low, it w ill cause overheating, and will also cause proble ms with corrosion due to ai r entering the coolant.